![]() It will pull the camera SD card out of the slot.so I loop the cable inside the camera and that helped stop my error. ![]() I get the disconnect if I am not careful closing the camera cover. I have not had any issues since I replaced the damaged cable(my fault) on my first cam early this summer. I also format the micro-SD card after a lot of pics. I tried formating the SD card on the cable once after it filled up with pics for some reason.might have been from cable damage. My first SpyPoint I did a softwear update after it stopped sending pics and getting messages similar to you. Also GPS still shows at my house, never showed at the property, usually says maps not supported.but it will show it at my house Then I start getting no sd card message.but it is there. Still get the message every few days with no pics. Check next time I am there.not disconnected, take loose and replace, changed out cable once. Everything shows good and then I get cable disconnected message a day or 2 later. Cell link shows 90%, all lights cycle and then go out as instructions say. I have a cell-link that will soon be used for target practice Tried it on 2 cams that save pics fine on their sd cards. Https:/ / shop/ pdp/ spypoint-cell-link-universal-cellular-adapter?sku=vzn If you buy year round plan I think it is like $12 for unlimited. Plans are $15/month for month to month for unlimited texts with no contract. The only cam that I have that Cell-Link would not work with was a was not software but the location of the SD card slot and how close the cover was to it when shut. A lot depends on signal strength and then number of night pics as far as battery life. I have pics sent 4 times per day and that saves on batteries, but I still get 5000-6000 pics with one set of Rayovac Alkaline batteries. If I have one bar on the Cell-Link it will send pics, but if there are a lot of pics it may take a while to get them all. ![]() Mine work pretty well in an area that does not have great cell coverage for ATT but Verizon works pretty well. I have used them on Tasco, Primos and Stealth Cam. I have two that I use with an older Bushnell and then one on a really old SpyPoint cam. All you needed was batteries and micro-SD card. Academy had them on sale for $35 with free shipping IIRC. Can you use a SpyPoint Cell-link with your existing Spartan cams? It would be a cheap alternative with existing cams you own.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |